Then turn the ratchet and it will self-center on the nut. Firstly, use an Allan wrench to loosen the setscrews and remove the faucet handle. With a pair of pliers, grasp the tip of the old shower faucet, and pull it straight out from the valve. Faucets come with features that vary from manufacturer to manufacturer, but if you want to remove a Delta faucet, the procedure won't be much different than removing any other type. There’s usually a cover plate that can be pried off with a flathead screwdriver. Once you have removed the handle of your Delta shower faucet, now remove the trim sleeve and spacer. Using needlenose pliers, remove the valve clip and pull the valve out of the wall. Start by removing the handle of the shower. How to Remove an Existing Shower & Tub Faucet. Remove the cap and handle as in the single handle guide. This style of faucet is known as a top-mount faucet, and it is by far the most common among modern faucets. A step-by-step interactive guide is also available to help you remove your KOHLER valve trim — Identifying and Removing Single-Control Shower Valve Trim. The difficulty of the procedure hinges on whether you're dealing with a sink or shower faucet. Once you have loosened the setscrews, the handle of your faucet should simply pull out. Remove all the screws that hold the other parts so that you can reach the shower handle stem. Locate the metal retaining ring or retainer clip or nut, whichever applies, that holds the cartridge in place and, with an adjustable wrench, loosen it and take it out. Slide the open end of the faucet wrench over the supply tube and push it up to the faucet nuts. To replace a shower valve, start by unscrewing the shower handle and trim plate, so you can remove them. Step 4 - Remove the Old Shower Faucet. The faucet on a combination tub and shower consists of a tub spout over the tub, a handle or handles and a shower head. A stem is always on the inner part of the shower system. Wrap Teflon tape around the threads of the new valve, leaving the first few threads bare to ensure a grip. Then, shut the water off and cut a hole in the small opening behind the trim plate, so you can reach the valve. To remove it, first, you have to take off all the other components such as the washer, handle, and diverter, and so on. If you want to change an old shower faucet, the easiest method is to choose a new faucet of the same style as the existing unit. The instructions still apply. The images below that show how to remove the valve trim may not look like exactly like your trim. You may have a sleeve over yours. Remove the escutcheon plate by unscrewing it. For most faucets, removal will involve removing flexible supply tubes and unscrewing mounting nuts that are threaded onto faucet tailpieces up under the sink. Remove and reattach the ratchet handle as you rotate the nut. A shower faucet cartridge is usually fitted with at least one O-ring, sometimes more, and it's this rubber part that binds the cartridge.Rubber is especially vulnerable to mineral accumulation, and after the faucet has been in use long enough, the O-rings … Then, hold the handle tight and unscrew the screw behind the cover plate with the same screwdriver. Remove faucet nuts with a faucet wrench. Look to see if there’s a water shutoff near the shower valve. Gently remove it, being careful not to mar the finish. With a socket wrench, remove the old valve. This can be achieved by simply pulling them out How to remove a shower handle stem? Cover the drain with tape to avoid the loss of any small parts.